This design is built by winding individual cores as 1:1 choke baluns and then cross connecting them. This creates a 4:1 current balun with excellent isolation and choking is the result. A very good choice to build a multiband Off Center Fed dipole around, but please note the caution statement below.
If you look closely at the images, you can see the individually wound cores that form the balun. Each core has 10 individual turns to generate maximum choking impedance and produce near perfect transformation. The black polymer spacer is used to insure proper separation of the individually wound cores at all times. The balun includes the Top Hanger Eyebolt so you have a complete package for your antenna project.
All testing done with an AIM-4170c Network Analyzer and precision 200 ohm load
If one or both legs of your OCF dipole will be installed over or close to (< 20 feet) your house, a large structure (garage, barn, etc) or near (< 30 feet) a metal roof/structure and you will run 700+ watts, DO NOT use this 4115ocf balun. The interaction/coupling of the antenna with the structure and or metal will create excessive flux in one core and subsequent damage to the balun. Instead use the Model 4114ocf which utilizes a single stacked core designed to handle the imbalance caused by any interaction or coupling.
There are a number of interesting designs for OCF dipoles available on our website
listed under the Support & Downloads tab at the top of the page
|Core Material|| Custom mix low permeability ferrite by Fair Rite Products for maximum bandwidth.
Cores are coated and sealed for long term durability.
|Winding Type|| Individual cores wound with single wire pair as 1:1 current balun.
Cores are then cross connected to create 4:1 current balun.
|Winding Material|| Bifilar windings of 14 gauge Heavy build polyamideimide Allex 240 Winding Wire.
Windings are inserted into Teflon tubes increasing total breakdown to 10,000 volts.
|Power Rating|| 1 to 35 MHz - 5kW, 7kW intermittent. 35 to 54 MHz - 4kW.
All ratings based on resonant load. High SWR will reduce power handling ability.
|Useable Frequency||1 to 54 MHz|
|Insertion Loss||Less than .02db|
|Connectors|| SO-239 connectors are silver plated with Teflon insulation.
Studs and eyebolts are 1/4 inch.
Alternate connectors and Mounting Options are available in the Accessories section.
|Hardware||All Stainless Steel|
|Enclosure Type|| NEMA rated 4x marine grade junction box for outdoor installations.
Cover utilizes integral neoprene gasket for weatherproof integrity.
|Dimensions||4x4x2 inches for main body of unit|
|Additional Info|| Very high efficiency (98-99%).